Is the automatic press plate of the engraving machine good?
If the engraving PCB should always be crushed on average, but if it is embossed, half of the time is suspended because it has been carved, I don’t know if it has any effect.
If you open the thick first, it is not pressed on the plane, I wonder if it will get stuck.
If the dust removal work is done well, it should be fine, or if you are carving acrylic, this should still be possible.
This platen can only be cut, not embossed
If you open the thick first, it is not pressed on the plane, I wonder if it will get stuck.
If the dust removal work is done well, it should be fine, or if you are carving acrylic, this should still be possible.
This platen can only be cut, not embossed
评论
发表评论